Durmast Oak decapè (CL)

Main features     Thickness Length Width
Engeniering wood on 3 Layer   Board dimensions 14/15mm 1700/2200mm 170/220mm
Connection joint in the 4 side          
Solid wood Oak layer 4mm          
Second Layer in Brich wood          
Final counterbalancing layer Oak       Ce UNI EN 14342:2013

Geographical provenience: 

SLOVIENIA EU

General Instructions:  

Cleaning instructions:

Under floor heating 

Our engineered wood is strongly recommended for beeing installed over under floor heating floor following this instructions:

  • Acclimatisation before fitting; Engineered wood flooring will require 7 to 10 days to acclimatise to the same conditions that they will experience in use.
  • Before fitting; the under floor heating system should be fully commissioned and fully operational with all components in place before any fitting commence; The under floor heating system should be switched off at least 48 hours before any fitting commences
  • During Fitting the under floor heating should remain off whilst the wood flooring is being fitting
  • Once all fitting has been completed the floor should be left for 24 hours before it is walked on; The heating should not be switched on until 72 hours after fitting has been completed. After can be switch off.
  • The under floor heating should then be switch on at it’s lowest heat probably approximately 18⁰C at finished floor level and the heat should then be gradually increased by gradually in 4 days and THE HEAT SHOULD NEVER EXCEED 30° FINISHED FLOOR LEVEL
|